Mill Diagnostic Electrician Description
Under general supervision safely maintain, install, repair and troubleshoot multiple types of electrical systems and equipment in support of a Mill/Processing site.
- Removal, repair and installation of electrical systems and components within the following areas and systems: mill (primary/regrind), leach area, packing area, boiler room, reagent area, acid house, general mill, conveyor equipment, air, water and power line systems
- Perform equipment electrical analysis and diagnosis, advanced troubleshooting and systems/process optimization
- Work on switch gear and distribution including grounding, LOTOTO procedures, and use of jumper forms
- Perform preventative maintenance including checking motors, checking for ground loops, metering electrical circuits, calibrating equipment and completing additional checks
- Review, revise and create SOP’s
- Perform GRC conduit bending and fastening: conduit, cable tray, grounds, boxes, and calculating loads and feeder sizes
- Train and mentor other Electrical department employees on:
- Proper testing of PPE
- Proper audit of Mill site
- Preventative maintenance (either electrical or instrumentation)
- Product flow and priorities
- New electrical installation
- Print reading
- Act as Fill-in Supervisor as needed
- May be required to use the following mobile equipment: forklifts, light duty vehicles, bucket trucks, high-lift trucks
- Perform other duties as required
Mill Diagnostic Electrician Qualifications
- Completion of an approved Certified Electronics, Electrical and/or Instrumentation program, OR
- Minimum of four (4) years of experience in Industrial Electrical and/or Instrumentation repair and maintenance, OR
- Associate’s degree or Trade School Certification in a related field and two (2) years of experience in Industrial Electrical and/or Instrumentation repair and maintenance
- Knowledge of AutoCAD drawings/prints, and electronic prints
- Knowledge of proper SOP’s
Preferred
- High School diploma or GED
- Experience with VFDs, PLC, HMI, and/or SCADA Control Systems
- Experience working with low and medium voltages
- Experience with AC and/or DC controls
- Experience with instrumentation devices
- Experience with diagnostic electrical test equipment
- Experience with HVAC equipment
#LI-DNI